HPE Ⅱ Series

HPE II is a new generation electronic portable hardness tester. The body is made of strong and light aluminum alloy. The contact pressure value designed by this instrument is completely in accordance with the official standard, and the measurement time can be adjusted to 0-99 seconds, electronic display, sound assistance to determine the measurement time and some testing errors. More patent handle simulation system standard load, and greatly improve the manual test stability. The measured data storage allows to store 300 results. After the measurement is done, the result will be saved automatically. The display will show "M" for memory. The saved data can be transferred with a data output RS 232 to a PC. The new generation of HPE II is suitable for production line personnel to make rapid and accurate hardness measurements for large area elastomers, large finished parts or standard test pieces.


  • thickness
  • standards

  • applications

technical specifications


DAkkS/DKD calibration certificate

When a measuring instrument is being calibrated, the given deviation is determined by various measurements versus standard references. A calibration certificate is then issued indicating the measuring results and the corresponding measurement uncertainties and the instrument is marked as calibrated. 

All documents together with the calibration certificate provide traceability of national standards.

Control ring Shore 20/40/60/80

Control of the measuring distance with DAkkS/DKD / WKS Certificate

  • 20 Shore
  • 40 Shore
  • 60 Shore
  • 80 Shore

Standard Rubber Blocks

Standard rubber blocks are used to ensure the metrological capability of the measuring device according to Shore, during the frequency of recalibration. The rubber blocks are embedded in a holder made of stainless steel. 

These blocks are available in :
single, 3, 5 or 6 plates including a DAkkS/DKD accredited calibration certificate

BS 61 II - manual stand

The measuring bracket on this manual stand is designed for our HP/HPE II durometers. When the portable hardness tester is used together with BS 61 II, it can effectively eliminate the measurement Angle and force error caused by improper operation. The same BS 61 II can be loaded with both shore A and shore D durometers (shore D needs to be loaded with additional weight). BS 61 II is also suitable for loading shore 00 or 000 durometers.


Length x width x height (cm) :  19.9 x 15.8 x 44.2

Weight (kg) : 5.5

DAkkS/DKD calibration certificate
Control ring Shore 20/40/60/80
Standard Rubber Blocks
BS 61 II - manual stand